Replacement of sanitary facilities in the hospital
Building a hospital is this type of building, which must run smoothly at all levels. Therefore, in addition to cleanliness in the bathrooms, also asks a lot of attention on the general state of water supply and sewerage hospital. This can prevent the occurrence of various unforeseen situations that could harm the good functioning of the hospital and the safety of his patients. Every few years should, therefore, check the status of the hospital water supply, sewerage and if necessary exchange the already clogged pipes that belong to the network. All of these activities can be carried out by a team of plumbers working in a nearby factory water and sanitation. From time to time you should also be exchanged sanitation in the hospital.
Wikipedia about plumbing systems
The major categories of plumbing systems or subsystems are:
potable cold and hot tap water supply
plumbing drainage venting
sewage systems and septic systems with or without hot water heat recycling and graywater recovery and treatment systems
Rainwater, surface, and subsurface water drainage
fuel gas piping
hydronics, i.e. heating and cooling systems utilizing water to transport thermal energy, as in district heating systems, like for example the New York City steam system.
Types of plastic pipes
Plastic pipe is a tubular section, or hollow cylinder, made of plastic. It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow ? liquids and gases (fluids), slurries, powders and masses of small solids. It can also be used for structural applications; hollow pipe is far stiffer per unit weight than solid members.
There are three basic types of plastic pipes:
Solid wall pipe
Extruded pipes consisting of one layer of a homogeneous matrix of thermoplastic material which is ready for use in a pipeline
Structured wall pipe
Structured-wall pipes and fittings are products which have an optimized design with regard to material usage to achieve the physical, mechanical and performance requirements. Structured Wall Pipes are tailor made solutions of piping systems, for a variety of applications and in most cases developed in cooperation with users
Pipe incorporating a flexible metallic layer as the middle of three bonded layers. Barrier pipe is used, for example, to provide additional protection for the contents passing through the pipe (particularly drinking water) from aggressive chemicals or other pollution when laid in ground contaminated by previous use.
Most plastic pipe systems are made from thermoplastic materials. The production method involves melting the material, shaping and then cooling. Pipes are normally produced by extrusion.